Kevin, would you mind sharing the specifics of your case turning setup?
motor.. brand, rpm, etc. does it wobble or run true?
shaft/shell holder connection?

I'm glad to see there's at least one more Texan on here!
I go thru Wichita Falls on my way to the panhandle & New Mexico as often as possible! (I'm near Beaumont near the coast, 100 miles east of Houston)

Not in a big rush, but I've struggled to come up with an effective, efficient way to turn necks, de-burr flash holes etc. Your setup looks clean and sounds like switching cases is pretty quick while remaining repeatable or uniform from case to case.

Thanks, Stretch
aka
Alan Davis
davisag@gmail.com
if it's easier to discuss this, my "dumb" cell phone number is 409.718.8369.