Go Back > ramos

Conversation Between ramos and SDguy605
Showing Visitor Messages 1 to 1 of 1
  1. SDguy605
    11-25-2014 04:58 PM
    I have PM'd him about his brass. Boils down to a two piece jig (Delrin or nylon) cut out semi close to the profile of the bullet or brass (under sized drilled hole. then a guide cut is made through the jig slightly off center tu guide very fine toothed hack saw blade. fine varying grades of fine emery paper and a glass plate to finish things up. See How close i match his reply.

All times are GMT. The time now is 12:48 AM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.