Saubier.com  



Go Back   Saubier.com > Members List

ramos ramos is offline

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. Silverfox
    06-08-2018 10:38 PM
    Silverfox
    Ramos--I'm contemplating a build of a 20 Vartarg rifle. I'm interested whether you would be interested in making at least three hundred 20 Vartarg casings for me out of Lake City .223 brass. If so, how much would your charge, including shipping?

    Thank you,

    LeRoy Benson (aka Silverfox)
    e-mail: willhigh@nemont.net
  2. ramos
    03-15-2017 04:50 PM
    ramos
    Hey Ralph,
    Think of you and your wife quite often. Hope you are finding a routine that works for both of you. Did you decide not to move, or is that still on the table? We went through a tough Winter here and then had a significant cardiac scare with my twelve year old (he has a history). Things are looking better here. We have started training this years Fair animals. Goats and beef, again. Stay in touch and take care, my friend.
    Jon
  3. JINGWEED
    03-15-2017 03:54 PM
    JINGWEED
    Hello there bud,
    Havent been in touch and im sorry about that. I dont need anything special only to check up on a good friend. YOU. LOL anyhow, I hope everything is going good with you and I really appreciate all your messages and support.
    Your friend,
    Ralph
  4. bburrell
    08-16-2016 12:14 AM
    bburrell
    Ramos, Thank you for acknowledging my comment in your post. I have had some regret after posting it as I felt that I was being too much in consultant mode and being too much in my head and philosophical. It is some comfort to know that someone did get something out of my comment. I always appreciate your insight and comments and look forward to reading more of them. Thank you for sharing. Burt
  5. Nor Cal Mikie
    12-05-2015 01:58 PM
    Nor Cal Mikie
    Jon:
    More listed @Savage Shooters, Mike.
    http://www.savageshooters.com/showth...727-5-56-Brass
  6. Bill K
    02-26-2015 10:30 PM
    Bill K
    Trying this again on the missed question.. I found the new/re-worked site, but same members, etc. at 204 Ruger Forum.. Bill K
  7. SDguy605
    11-25-2014 03:58 PM
    SDguy605
    I have PM'd him about his brass. Boils down to a two piece jig (Delrin or nylon) cut out semi close to the profile of the bullet or brass (under sized drilled hole. then a guide cut is made through the jig slightly off center tu guide very fine toothed hack saw blade. fine varying grades of fine emery paper and a glass plate to finish things up. See How close i match his reply.

About Me

  • About ramos
    Location
    Sherman County, Oregon
    Interests
    reloading, shooting, fishing, boating, kids, reading
    Occupation
    Ag Parts Manager

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 02-11-2020 08:03 PM
  • Join Date: 06-18-2010
  • Referrals: 1

Friends

Showing Friends 1 to 2 of 2

All times are GMT. The time now is 05:39 AM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.