Saubier.com - .19 cal bullets

Page 2 of 4

Show 40 post(s) from this thread on one page

Saubier.com (http://www.saubier.com/forum/index.php)

- Bullet Making (http://www.saubier.com/forum/forumdisplay.php?f=3)

- - .19 cal bullets (http://www.saubier.com/forum/showthread.php?t=12757)

Dick Kohles

02-04-2011 07:12 PM

This was from: http://www.jbmballistics.com/cgi-bin...j_simp-5.1.cgi
Shot 10 rounds over a chrongraph at 10 feet, added 15 fps to the average and than shot 10 rounds over the same chronograp at 200 yards. .235 was the ballictic coefficient result.
Dick

kenbro

02-05-2011 07:35 AM

Thanks Dick, Much appreciated.
Ken.

Dan C

02-05-2011 05:03 PM

Ken, there are ballistic tables with B.C. values on Calhoon's web site on the 19 caliber page. It's an underlined link called "click here for complete ballistic tables" or something like that. It does not have the new Sabre Tip but Dick's data for that bullet sounds about right to me.

Dan

kenbro

02-06-2011 08:49 AM

Thanks Dan. I had printed Mr. Leahys pages off but for some reason that info wasn't amongst it, will look again.
Ken.

potatohead

02-07-2011 09:12 PM

Quote:

Originally Posted by 17VLD (Post 93278)

I believe Corbin makes them,they take the 20 cals down to 19 cal.
Pretty sure James starts with the 32grn Nosler to make his Sabre tips.
I remember way back when James was considering making these
poly tip bullets his biggest hurdle was finding dies to make the little tips.
I'm glad he is doing this for us I for one like the polys with their better bc.
Matt

Thanks 17VLD, I will look into it with Corbin. I wish I could get some more info in the process. Thanks

Gary in Illinois

02-07-2011 09:16 PM

Corbin

Look around on Dave Corbin's site. I believe he has a lot of information free for downloading that will provide hours of reading.

Good luck,
Gary

MIBULLETS

02-07-2011 11:28 PM

17VLD has it right. Corbin makes a bullet reducing die to do this. Go to the link here and go to the bullet draw die section. You can get them to fit a normal reloading press. You just push the bullet though a correctly sized ring die.

http://www.corbins.com/drawdies.htm#brd

Dan

potatohead

02-08-2011 04:54 PM

Thank you Dan, I think I need the BRD-R Draw die but will just call and to check as I wasn't able to find it on the pricing sheet. Thanks again for the link!!

Charlie

MIBULLETS

02-08-2011 09:33 PM

No problem Charlie! Hope it works out for you. If you get one and reduce some 20 calibers to 19 let us know your progress. I'm sure a lot of us will be interested in the results.

Dan

kenbro

02-09-2011 08:50 AM

After a quick look on Corbins site I came away thinking the reduction from .204 to .198 may be a step too far for that setup. Am I missing something here?
Ken.

All times are GMT. The time now is 03:43 AM.

Page 2 of 4

Show 40 post(s) from this thread on one page