Saubier.com  



Go Back   Saubier.com > Search Forums

Showing results 1 to 25 of 272
Search took 0.04 seconds.
Search: Posts Made By: DAVID
Forum: Project Guns 11-25-2020, 10:13 PM
Replies: 1
Views: 1,592
Posted By DAVID
Very nice looking rifle, and great caliber choice!

Very nice looking rifle, and great caliber choice!
Forum: Project Guns 11-09-2020, 11:01 PM
Replies: 15
Views: 7,311
Posted By DAVID
I finally got out to shoot BIG MAX the other day...

I finally got out to shoot BIG MAX the other day @ 100 yards, and was definitely not disappointed with the results.

Groups were measured outside to outside/ minus bullet diameter / .357

Since...
Forum: Big Game 10-25-2020, 04:40 PM
Replies: 12
Views: 9,968
Posted By DAVID
A most excellent job Lillie, congratulations!

A most excellent job Lillie, congratulations!
Forum: Classifieds 10-17-2020, 10:33 PM
Replies: 0
Views: 333
Posted By DAVID
WTB: Blaine Eddy case forming block

I am wanting to buy one of Blaine Eddy's case forming blocks. Send me a PM if you know where I can locate one.

Thanks guys!

DAVID
Forum: Project Guns 10-15-2020, 05:38 PM
Replies: 15
Views: 3,465
Posted By DAVID
Just curious, why a 1-12" twist instead of a...

Just curious, why a 1-12" twist instead of a 1-14" or 1-16" twist?

I use the latter 2 twist rates, and they both shoot very with bullets up to and including 55 gr..
Forum: Project Guns 10-13-2020, 06:27 PM
Replies: 15
Views: 7,311
Posted By DAVID
Thank you Matt, I appreciate the complimens, and...

Thank you Matt, I appreciate the complimens, and my wife said to tell you thank you!

Even if it is, or was just a plain ole H&R, I am proud of the way this gun turned out, and still very impressed...
Forum: Project Guns 10-11-2020, 07:03 PM
Replies: 15
Views: 7,311
Posted By DAVID
We left the range early today because of the...

We left the range early today because of the heat, and my sweet little wife got to shoot something better than paper!
...
Forum: Project Guns 10-10-2020, 01:04 AM
Replies: 15
Views: 7,311
Posted By DAVID
I appreciate the compliments csterner, but I have...

I appreciate the compliments csterner, but I have seen a lot of bench guns that would put this "hunting" gun to shame!

After building this particular 357 Maximum, I had to wait over 4 months...
Forum: Project Guns 10-01-2020, 05:53 PM
Replies: 15
Views: 7,311
Posted By DAVID
The only negative thing that I can say about this...

The only negative thing that I can say about this gun, is that I was so disappointed that it would not shoot Hornady's 140 gr. FTX bullets! Outside of that, I am very satisfied with how well this gun...
Forum: Project Guns 10-01-2020, 05:12 PM
Replies: 15
Views: 7,311
Posted By DAVID
All of these 3-shot groups were shot at 200...

All of these 3-shot groups were shot at 200 yards, with the 3X-12X variable scope set on 12X.
...
Forum: Project Guns 10-01-2020, 05:07 PM
Replies: 15
Views: 7,311
Posted By DAVID
Let me first say, that this gun just flat out...

Let me first say, that this gun just flat out would NOT shoot accurately when using sand bags, regardless of where the front bag was positioned under the forend! My Harris B-R solved that problem...
Forum: Project Guns 10-01-2020, 04:56 PM
Replies: 15
Views: 7,311
Posted By DAVID
https://hosting.photobucket.com/images/z132/Honker...

https://hosting.photobucket.com/images/z132/HonkerHunter_photos/20200902_145242.jpg?width=1920&height=1080&fit=bounds...
Forum: Project Guns 10-01-2020, 04:53 PM
Replies: 15
Views: 7,311
Posted By DAVID
357 Maximum!

Here is an H&R barrel stubbed rifle that I built and chambered in 357 Maximum, with the story behind it.

A couple of years ago, I bought a Shilen Select Match Grade stainless steel barrel blank in...
Forum: Small Caliber Discussion Board 09-29-2020, 11:58 PM
Replies: 11
Views: 1,094
Posted By DAVID
Way to go Lillie, and nice shooting! You did...

Way to go Lillie, and nice shooting!

You did good on cartridge choice too!

I'm anxious to see what you are going to get this deer season. Good luck!
Forum: Small Caliber Discussion Board 06-01-2020, 06:40 PM
Replies: 17
Views: 1,920
Posted By DAVID
I don't remember if it was mentioned or not, but...

I don't remember if it was mentioned or not, but the Remington 7 1/2 primer is a "Magnum/Match" primer, and is an excellent primer for use in a LOT of different cartridges! I use it in all of my 357...
Forum: Small Caliber Load Data 05-21-2020, 05:54 AM
Replies: 7
Views: 1,393
Posted By DAVID
Your fireform loads should jam the rifling to...

Your fireform loads should jam the rifling to help minimize headspace.

For the favorable reloading manuals that do have 6mm TCU load data listed, use at least a "middle listed load" to help make...
Forum: Small Caliber Load Data 05-21-2020, 12:10 AM
Replies: 7
Views: 1,393
Posted By DAVID
I shoot a switch barrel Remington M7 in the...

I shoot a switch barrel Remington M7 in the following cartridges:

6mm TCU

257 TCU

7MM TCU

30 TCU
Forum: Project Guns 05-19-2020, 12:07 AM
Replies: 17
Views: 4,136
Posted By DAVID
Text sent.

Text sent.
Forum: Project Guns 05-17-2020, 11:09 PM
Replies: 17
Views: 4,136
Posted By DAVID
Thank you 6BRBB, and it most certainly is! I...

Thank you 6BRBB, and it most certainly is!

I have done all I can do in long-range shooting, as well as high-accuracy shooting, but these "3" .45's that you can shoot in the same chamber, are just...
Forum: Project Guns 05-14-2020, 02:45 PM
Replies: 17
Views: 4,136
Posted By DAVID
GLWenzl, just let me know when you get ready...

GLWenzl,

just let me know when you get ready to do something!

When it comes to barrel stubs, my 45 Auto Rim / 45 Auto / 45 Super is one of the most fun guns I have ever owned!

I have never...
Forum: Project Guns 05-12-2020, 05:29 AM
Replies: 17
Views: 4,136
Posted By DAVID
I wish I had a crappie Savage action! I would...

I wish I had a crappie Savage action! I would build a single shot .45 acp with a bull barrel, 23" long and put it in a good fitting stock and shoot it till the cows came home!
Forum: Project Guns 05-11-2020, 09:11 PM
Replies: 17
Views: 4,136
Posted By DAVID
ray h, there was absolute zero muzzle blast...

ray h,

there was absolute zero muzzle blast increase after shortening the barrel from 31 1/2" down to 22"!

I set up my "decimal reader" when shooting both barrel lengths, and the decimal...
Forum: Project Guns 05-11-2020, 04:21 PM
Replies: 17
Views: 4,136
Posted By DAVID
I just couldn't leave well enough alone! ...

I just couldn't leave well enough alone!

https://hosting.photobucket.com/images/z132/HonkerHunter_photos/20200408_085043_1.jpg?width=1920&height=1080&fit=bounds...
Forum: Project Guns 03-20-2020, 07:51 PM
Replies: 17
Views: 4,136
Posted By DAVID
The final build! ...

The final build!

https://i193.photobucket.com/albums/z132/HonkerHunter_photos/45%20Auto%2012%20ga/20200318_174520%201_zpspyrx1bjp.jpg

...
Forum: Project Guns 03-20-2020, 07:38 PM
Replies: 17
Views: 4,136
Posted By DAVID
Barrel liner has been cut and crowned at 19 1/2"...

Barrel liner has been cut and crowned at 19 1/2" and the shotgun barrel will be left full length at 31 1/2".

...
Showing results 1 to 25 of 272

 
Forum Jump

All times are GMT. The time now is 10:39 PM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.