Saubier.com  



Go Back   Saubier.com > Search Forums

Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: MIBULLETS
Forum: Classifieds 02-20-2024, 01:30 AM
Replies: 15
Views: 1,705
Posted By MIBULLETS
No disrespect George, but you didn't understand...

No disrespect George, but you didn't understand my response. In no way did I say the that .7gr was an acceptable error in a small case. What I did say is that the scale could be off by a percentage...
Forum: Classifieds 02-11-2024, 12:56 AM
Replies: 15
Views: 1,705
Posted By MIBULLETS
I see I misunderstood the OPs original post, so...

I see I misunderstood the OPs original post, so my previous post isn't relevant to the question.

I see the recommendations to clean the balance scale. I agree. My old RCBS scale was acting funny a...
Forum: Classifieds 02-08-2024, 12:59 AM
Replies: 15
Views: 1,705
Posted By MIBULLETS
Usually, the scale might have a range of...

Usually, the scale might have a range of acceptable deviation. In your case .7 gr off at 154 gr is only about 1/2 of a percent, which isn't bad really. If I were you, I would verify that the...
Forum: Small Caliber Load Data 02-08-2024, 12:42 AM
Replies: 12
Views: 1,737
Posted By MIBULLETS
I would try the Sierra 40gr Hornet bullet in .224...

I would try the Sierra 40gr Hornet bullet in .224 diameter. (They make it in .223 diameter also for older barrels). Nice short but accurate bullet.
...
Forum: Classifieds 12-12-2023, 01:41 AM
Replies: 12
Views: 2,581
Posted By MIBULLETS
I thought I had a few boxes, but apparently I...

I thought I had a few boxes, but apparently I must have used them. All I can find is a partial box with 56 bullets.
Forum: Small Caliber Discussion Board 12-03-2023, 02:34 PM
Replies: 7
Views: 4,040
Posted By MIBULLETS
Was there also an article where he tested the...

Was there also an article where he tested the K-Hornet?
Forum: Bullet Making 02-13-2023, 12:38 AM
Replies: 4
Views: 35,626
Posted By MIBULLETS
Ok, I do have a partial bucket of .800" but not...

Ok, I do have a partial bucket of .800" but not sure I want to part with that many.
Forum: Bullet Making 01-21-2023, 03:03 PM
Replies: 4
Views: 35,626
Posted By MIBULLETS
What length are you looking for? How many is a...

What length are you looking for? How many is a moderate amount?
Forum: Small Caliber Discussion Board 05-30-2021, 02:20 AM
Replies: 5
Views: 2,942
Posted By MIBULLETS
I have 2 and both work fine with the K Hornet.

I have 2 and both work fine with the K Hornet.
Forum: Bullet Making 01-20-2021, 11:17 PM
Replies: 11
Views: 219,013
Posted By MIBULLETS
Important question is... How did they shoot?

Important question is... How did they shoot?
Forum: Small Caliber Discussion Board 12-29-2020, 03:40 AM
Replies: 17
Views: 6,500
Posted By MIBULLETS
I second this, my 22 K Hornet loved those 45 gr...

I second this, my 22 K Hornet loved those 45 gr solid base bullets.
Forum: Small Caliber Discussion Board 12-28-2020, 03:17 AM
Replies: 17
Views: 6,500
Posted By MIBULLETS
I think they may have been the predecessor to the...

I think they may have been the predecessor to the Ballistic Tip. Same solid base and lead tip instead of plastic.
Forum: Small Caliber Discussion Board 12-03-2020, 12:25 AM
Replies: 27
Views: 9,305
Posted By MIBULLETS
Totally agree with you on that Bill. In that...

Totally agree with you on that Bill. In that case, I don't think it would matter what they had with them though, including a rifle of any caliber. I tend to think those on this forum could probably...
Forum: Small Caliber Discussion Board 12-01-2020, 12:19 AM
Replies: 27
Views: 9,305
Posted By MIBULLETS
Why not just carry a large side arm with you? ...

Why not just carry a large side arm with you? 44mag or larger?
Forum: Bullet Making 11-11-2020, 10:57 PM
Replies: 11
Views: 219,013
Posted By MIBULLETS
I have never used it so I can't say from...

I have never used it so I can't say from experience. I've found that if I clean the cores well and remove all the lubricant from the squirting operation they stick fine. I usually just wash them in...
Forum: Bullet Making 11-11-2020, 02:00 AM
Replies: 11
Views: 219,013
Posted By MIBULLETS
I think the best solution is to use a smaller...

I think the best solution is to use a smaller core so that the air doesn't get trapped.
Forum: Small Caliber Discussion Board 10-25-2020, 12:25 AM
Replies: 7
Views: 3,978
Posted By MIBULLETS
If you just installed it and you have a lot of...

If you just installed it and you have a lot of data stored, it could take quite a while for the initial scan since it is scanning everything. Subsequent scans usually only scan anything new or things...
Forum: Small Caliber Discussion Board 10-06-2020, 02:49 AM
Replies: 32
Views: 11,184
Posted By MIBULLETS
13 gr of LG is too much for my Ruger 77/22Hornet...

13 gr of LG is too much for my Ruger 77/22Hornet that has been K'd. It likes around 12.5 gr. At that level I see no issues. The only thing I don't love about LG is that it is dirty. Almost like...
Forum: Small Caliber Discussion Board 10-04-2020, 01:07 AM
Replies: 5
Views: 2,916
Posted By MIBULLETS
I had not heard that, but don't think it would be...

I had not heard that, but don't think it would be a bad thing.
Forum: Small Caliber Load Data 10-04-2020, 01:04 AM
Replies: 8
Views: 13,483
Posted By MIBULLETS
Hopefully the prices don't go up.

Hopefully the prices don't go up.
Forum: Small Caliber Load Data 08-05-2020, 02:30 AM
Replies: 18
Views: 9,765
Posted By MIBULLETS
How much neck tension does your brass have? If...

How much neck tension does your brass have? If you have to press very hard to seat a bullet any brand die could cause a ring. You may also want to just polish the spot where the ring is in the...
Forum: Classifieds 04-07-2020, 03:56 AM
Replies: 6
Views: 3,798
Posted By MIBULLETS
I'll try to dig through my stuff in the next few...

I'll try to dig through my stuff in the next few days and see what I have. I'm sure I have some that I won't use anymore.
Forum: Classifieds 04-06-2020, 03:04 AM
Replies: 6
Views: 3,798
Posted By MIBULLETS
Does it matter if it was fired multiple times or...

Does it matter if it was fired multiple times or if it has been formed to 22 K Hornet?
Forum: Bullet Making 03-15-2020, 06:34 PM
Replies: 11
Views: 287,127
Posted By MIBULLETS
I really doubt that you would have a usable...

I really doubt that you would have a usable bullet doing that. It's quite a large reduction and the tip will most likely get pushed out or deformed.
Forum: Small Caliber Discussion Board 03-08-2020, 07:02 PM
Replies: 13
Views: 6,606
Posted By MIBULLETS
Might want to look at your expander die setting...

Might want to look at your expander die setting also.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 04:37 PM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.