Forum: Classifieds
02-22-2022, 09:29 PM
|
|
Replies: 8
Views: 946
Rel 7
You have a PM.
Chuck
|
|
Forum: Small Caliber Discussion Board
12-29-2021, 03:24 PM
|
|
Replies: 12
Views: 1,063
Hornady LNL
I have the Hornady Projector press which was the precursor to the LNL I do not use the primer feed (due to poor design) or factory powder measure. I prime before using the press and manually drop...
|
|
Forum: Classifieds
10-29-2021, 08:54 PM
|
|
Replies: 0
Views: 796
|
|
Forum: Small Caliber Discussion Board
10-08-2021, 05:22 AM
|
|
Replies: 2
Views: 888
Powder load following fireforming 20 PPC
What change can I expect in powder loads after fireforming 220 Russian Lapua brass? I have read that some people use the same powder load for fireformed brass in other cartridges and some use less. ...
|
|
Forum: Classifieds
09-25-2021, 03:47 PM
|
|
Replies: 4
Views: 882
Leupold 4-12 scope
I have one in exceptional condition with a 3" sunshade and bikini scope cover. However, I had Leupold install high target turrets as I could not stand the coin slot adjustment turrets. There are no...
|
|
Forum: Small Caliber Load Data
08-29-2021, 03:07 PM
|
|
Replies: 7
Views: 13,016
17FB powder
Used H335 in my 17MIV shooting 25 gr pills. Loaded for 3,750 fps. Easy powder measure dispensing.
Chuck
|
|
Forum: Classifieds
07-26-2021, 06:28 PM
|
|
Replies: 7
Views: 1,348
17 hmr
Sorry guys - did not post price before was sold on Rimfire Central.
Chuck
|
|
Forum: Classifieds
07-24-2021, 12:11 AM
|
|
Replies: 7
Views: 1,348
Sako Quad Synthetic 17HMr - Sold pending funds
SOLD -New - never fired -$800.00. Shipped in original factory box with outer shipping box. Need copy of your FFL recipient. Shipping will include signature required and insurance. $50 shipping in...
|
|
Forum: Classifieds
06-02-2021, 03:43 PM
|
|
Replies: 9
Views: 2,097
|
|
Forum: Project Guns
05-24-2021, 05:37 PM
|
|
Replies: 18
Views: 12,639
Shooting suppressed
Just got back from shooting PDs. I was shocked that my suppressed 222 did not work any better for preventing them from going down at short distances. The expense and hassle of getting the...
|
|
Forum: Small Caliber Discussion Board
05-04-2021, 02:50 PM
|
|
Replies: 17
Views: 3,917
22 Rimfire suppressor +
Silencer Co makes a take apart suppressor for rimfires called the Sparrow. I have found that it has to be cleaned after 350 rounds or it will become very difficult to take it apart. A suppressed...
|
|
Forum: Small Caliber Discussion Board
04-26-2021, 04:09 PM
|
|
Replies: 30
Views: 8,625
25 cal V-Max
Bill:
Sorry - Made a mistake - meant to say that they made a shotgun pattern in my 1-10 barrel. Had the gun built in the 90's when the 17 gr V-Max did not exist. The Hornady 25gr HP would shoot...
|
|
Forum: Small Caliber Discussion Board
04-25-2021, 06:53 PM
|
|
Replies: 30
Views: 8,625
Hornady 17 cal 25 gr HP
This bullet works in my 10 twist 17mach 4 while the 25 gr V-Max never makes it to the target and that is only @ 3750 fps. Under calm conditions will get 1/2 MOA groups. Does not work well in...
|
|
Forum: Small Caliber Discussion Board
01-23-2021, 02:59 PM
|
|
Replies: 25
Views: 7,042
40gr 20 cal cartridge
A 20 Practical would not be much of a powder drop from a 20 PPC. A 20-222 would be less, but not as much as a 20VT. If I were to choose, I would go with the 20-222. JMO.
Chuck
|
|
Forum: Classifieds
01-18-2021, 02:09 PM
|
|
Replies: 4
Views: 1,577
Sierra 50 gr Blitzking
I would trade for 20 cal 39 gr Sierras, but would not be back home (where they are) until April 1st. Probably too long a wait, but let me know if intterested.
Chuck
|
|
Forum: Small Caliber Load Data
12-16-2020, 03:08 PM
|
|
Replies: 11
Views: 10,713
20 Practical powder
I use H335 for the 39 gr Sierra. I assume Benchmark and W844 (older surplus) would also work.
Chuck
|
|
Forum: Small Caliber Discussion Board
10-05-2020, 03:36 PM
|
|
Replies: 35
Views: 6,924
25 gr 17 cal HP
They work in my 10 twist 17MIV barrel. 25 cal V-Max will not as they keyhole.
Chuck
|
|
Forum: Small Caliber Discussion Board
09-19-2020, 05:00 PM
|
|
Replies: 20
Views: 5,096
17MIV loads
I found that H335 worked well, but I kept my velocity at 3750. Benchmark is about the same for burning rate. I was never able to get better than 1/2" groups with 3 or 4 touching and 1 out of the...
|
|
Forum: Small Caliber Discussion Board
09-19-2020, 04:26 PM
|
|
Replies: 5
Views: 1,340
Neck thickness
+1 on Nor Cal Mikie's recommendation. If you have .254 necks, you will probably have to turn them to sllow some clearance for a .254 neck chamber. If you wind up with a barrel having a .250 neck...
|
|
Forum: Small Caliber Discussion Board
09-12-2020, 02:07 PM
|
|
Replies: 20
Views: 5,096
17 Fireball or 17 MIV Twist
I highly recommend going with a 1 in 9 twist. My L461 in 17MIV with a 1 in 10 twist will keyhole the 25 gr V-Max bullet. I am able to shoot the Hornady 25 gr HP. but the BC is significantly lower...
|
|
Forum: Small Caliber Discussion Board
08-21-2020, 06:19 PM
|
|
Replies: 12
Views: 3,399
22 wmr
I had an old Ruger 77 all weather stainless (paddle tail stock) that shot 1" groups @ 100 yds. The trigger was lightened to 1#. Would only work with 40 gr Winchester ammo. I decided that going to...
|
|
Forum: Small Caliber Discussion Board
08-05-2020, 03:22 PM
|
|
Replies: 18
Views: 3,307
|
|
Forum: Small Caliber Discussion Board
08-01-2020, 02:58 PM
|
|
Replies: 18
Views: 3,307
Also looking for opinions
I have a 223 that I am working up a load for. Most of my powders are from the 90's. Have H335, Win 748, WC844. H335 has been a favorite, but want to use up my Win 748. My old Hodgdon manual has a...
|
|
Forum: Small Caliber Load Data
07-26-2020, 09:40 PM
|
|
Replies: 1
Views: 4,386
|
|
Forum: Small Caliber Load Data
07-26-2020, 08:59 PM
|
|
Replies: 1
Views: 4,386
|
