Forum: Bullet Making
04-11-2020, 04:49 PM
|
Replies: 5
Views: 263,462
17 cal tipping die
Whidden makes one. I got mine a couple of years ago. I also have the 17 cal meplat trimmer.
|
Forum: Bullet Making
02-02-2018, 09:21 PM
|
Replies: 7
Views: 189,142
17 cal hp tool
I have the Whidden Gunworks bullet pointing die in 17 cal. Works real good. Just be careful. You can't close the point all the way. If you go to far
, there will be a ring on the ogive from to much...
|
Forum: Bullet Making
12-26-2017, 04:08 PM
|
Replies: 16
Views: 302,090
Jackets
.021 thick wall, pretty heavy duty. .566 will make light bullets. Looks like you would need .170 wire for the cores.
|
Forum: Small Caliber Discussion Board
01-17-2017, 11:21 PM
|
Replies: 7
Views: 4,974
Bullets.com
They also refused to ship anything to New York.
|
Forum: Bullet Making
01-12-2016, 09:31 PM
|
Replies: 30
Views: 51,968
|
Forum: Bullet Making
12-19-2015, 06:18 PM
|
Replies: 7
Views: 9,177
|
Forum: Small Caliber Discussion Board
07-20-2015, 10:49 PM
|
Replies: 18
Views: 5,776
|
Forum: Small Caliber Discussion Board
04-16-2015, 10:25 PM
|
Replies: 20
Views: 5,943
Pm
I got one 4/15/15at 1:11
|
Forum: Small Caliber Discussion Board
03-17-2015, 10:09 AM
|
Replies: 16
Views: 5,906
|
Forum: Small Caliber Discussion Board
01-20-2015, 10:01 AM
|
Replies: 10
Views: 4,812
|
Forum: Bullet Making
01-18-2015, 12:34 PM
|
Replies: 7
Views: 6,489
Cores
Are your cores cast or from wire? If wire, where did the wire come from. Could be voids in the wire.
|
Forum: Small Caliber Discussion Board
01-12-2015, 10:06 PM
|
Replies: 17
Views: 7,776
22-6mmai
From what I have read, this round is a legitimate 1000yd round. There is a write up on this round in guns and ammo a couple of years ago. I will try and find the article.
|
Forum: Small Caliber Discussion Board
01-04-2015, 09:05 PM
|
Replies: 14
Views: 8,096
17 hmr
Sweet looking rifle. I imagine there will be lots of squirrels on its dance card..
|
Forum: Small Caliber Discussion Board
12-29-2014, 09:20 AM
|
Replies: 13
Views: 5,891
Pete and HG Firearms
I have to state in the strongest possible way: I AM NOT IN ANY WAY ASSOCIATED WITH HG FIREARMS. I bought some punches and draw dies from John. They were all out of spec. I DID NOT BUY HIS BUSINESS OR...
|
Forum: Bullet Making
12-12-2014, 02:19 AM
|
Replies: 7
Views: 9,177
copper strip
I use a power press to make my jackets. A lot less work than by hand.
|