View Single Post
  #7  
Old 05-06-2017, 12:27 AM
AzSam AzSam is offline
Supporting Member
 
Join Date: Jan 2011
Posts: 370
Default

Hi there.
This is my preference. May not be the fastest, but it works for me. I clean my cases, then size on my single stage, followed by tossing them a tumbler with plain untreated corn cob media and let the tumbler remove the lube. Naturally any other prep work- trimming, primer crimps dealt with, will need be done somewhere along way and make sure all the media is out of case and flash hole. (I usually do all this right after they are shot so they are all ready to load when time comes) Once all prep work is done I run them through the Dillon.
All the best.
Michael.

Last edited by AzSam; 05-06-2017 at 01:00 AM.
Reply With Quote