View Single Post
  #3  
Old 05-17-2018, 10:49 AM
DAA DAA is offline
Senior Member
 
Join Date: Oct 2006
Location: West Bountiful, Utah
Posts: 787
Default

There are a lot of good ones. I had and used the Sinclair a lot and liked it. But I replaced it with the K&M.

I just find it easier to get the K&M adjusted to exactly where I want it. And I also like to power the operation by turning the cutter in a drill press, the protruding mandrel on the back side of the K&M makes this easy too.

- DAA
Reply With Quote