Thanks to all who pointed me in a direction of information.
As mentioned above I just kind of fell into these by accident. Just what I need another project.......or investment. I have been reading and chasing data and info.
I am up in the air so to speak on wether to move forward with these and see what I can make. I am in them cheap enough I could spend a few hundred and still not be in bad shape, investment wise.
Expectations, a bare minimum of MOA out to 200 yards. If I settle for worse than that I feel it is a waste of time energy and effort. I can deal with the occasional flyer in a group.
I have an abundance of lead, but less time to cast. I see most prefer to swage cast cores to uniform any way. I would lean towards lead wire fore cores. I think I can build a core cutter fairly cheap.
Just going to fiddle with it as time allows. I stuck my toe into casting 20 some years ago. That was the deepest puddle I ever stepped into. Went into it over my head in short order.
Jeff
|