View Single Post
  #4  
Old 05-30-2018, 12:10 AM
squirrel_slayer squirrel_slayer is offline
Senior Member
 
Join Date: Jan 2013
Posts: 510
Default

you can also setup a target at say 300 yards zero the rifle at 100 and chrono the load then measure the POI vs POA then use your strelok to reverse engineer the BC.

Ie. rifle zero'd @ 100yd @xyz ft/sec with .xxx bc= drop @ 300

just keep changing the bc till it matches up then verify by stretching it to 400-500. fine tune if needed remember to find the centerline of the verticle dispertion of the group don't worry about what the wind is doing.
Reply With Quote