To hold the firing pin in the correct position, I use my borescope to look in the hole, but any good magnifying lens should work. After you get the holes lined up, just install the cone point setscrew and tighten it a little. Next install the second setscrew with a little blue locktite to bind the first one in place. Let it sit for a little while so the locktite has time to set up and you should be good to go. Forgot to say that after you disassemble, make sure to wash all the lubricant off all the pieces so that the locktite will bond to the steel and don't re-lube untill it has time to set.
|