#1
|
|||
|
|||
22 Hornet & K-Hornet dies, reamers, gauges!
Rebarreling my 22 K-Hornet to 19 Calhoon & have the following stuff that anyone who has a Hornet or is thinking of a "K" could very well need. Reamer has done two chambers. Everything is in great condition.
Lee Pacesetter 3-die set in 22 Hornet. FL, seater, & factory crimp. Seater & factory crimp work on "K" as well. $25 Redding 22 K-Hornet full-length size die. $40 Redding 22 K-Hornet neck size die. $40 (works on regular Hornet, too) Clymer finish reamer in 22 K-Hornet. $80 22 Hornet Clymer go & no-go gauges (used for "K", also) $20 each If you are converting to a "K" this is everything you need!! Near as I can tell shipping will be about $6 per item, but less if multiple purchases can be combined in one box cost. Buy everything & I'll cover the shipping. |
#2
|
|||
|
|||
I have a buyer for the FL K Hornet. Adam
|
#3
|
|||
|
|||
I will take the gauges
|
#4
|
|||
|
|||
k-hornet
I would buy some 22 k-hornet brass if you have any..greg 720 470 2598
|
#5
|
|||
|
|||
Brass was pretty worn out so I already tossed it.
|
#6
|
|||
|
|||
Gauges SPF!
Gauges are sold pending funds!
|
#7
|
|||
|
|||
Never had a K-Hornet! But, you will love the 19 Calhoon!! Working on loads for my 24 Calhhoon now (19 Calhoon necked up to 6mm). At 15 grains of 1680 on 55 grain Noslers - acceptable accuracy-but think I can better it with a 1/10 of a grain or so adjustment! Then doing the chrono-tests for velocity...
Bill
__________________
"Burn Powder, Not Comrades"! |
#8
|
|||
|
|||
Quote:
|
#9
|
|||
|
|||
O.H.
Sent a PM on a source for 1680.... Bill
__________________
"Burn Powder, Not Comrades"! |
#10
|
|||
|
|||
Reamer
Is the k-hornet reamer still available?
|
Thread Tools | |
Display Modes | |
|
|