#11
|
|||
|
|||
This was from: http://www.jbmballistics.com/cgi-bin...j_simp-5.1.cgi
Shot 10 rounds over a chrongraph at 10 feet, added 15 fps to the average and than shot 10 rounds over the same chronograp at 200 yards. .235 was the ballictic coefficient result. Dick |
#12
|
|||
|
|||
Thanks Dick, Much appreciated.
Ken.
__________________
" Pay it forward buddy" Get up each morning and don’t let the old man in. (Clint Eastwood). |
#13
|
|||
|
|||
Ken, there are ballistic tables with B.C. values on Calhoon's web site on the 19 caliber page. It's an underlined link called "click here for complete ballistic tables" or something like that. It does not have the new Sabre Tip but Dick's data for that bullet sounds about right to me.
Dan
__________________
--Dan C "Special appetite skill combine with brain lentil size create the deadliest!" |
#14
|
|||
|
|||
Thanks Dan. I had printed Mr. Leahys pages off but for some reason that info wasn't amongst it, will look again.
Ken.
__________________
" Pay it forward buddy" Get up each morning and don’t let the old man in. (Clint Eastwood). Last edited by kenbro; 02-06-2011 at 08:50 AM. Reason: spelling |
#15
|
|||
|
|||
Quote:
|
#16
|
|||
|
|||
Corbin
Look around on Dave Corbin's site. I believe he has a lot of information free for downloading that will provide hours of reading.
Good luck, Gary |
#17
|
|||
|
|||
17VLD has it right. Corbin makes a bullet reducing die to do this. Go to the link here and go to the bullet draw die section. You can get them to fit a normal reloading press. You just push the bullet though a correctly sized ring die.
http://www.corbins.com/drawdies.htm#brd Dan |
#18
|
|||
|
|||
Thank you Dan, I think I need the BRD-R Draw die but will just call and to check as I wasn't able to find it on the pricing sheet. Thanks again for the link!!
Charlie |
#19
|
|||
|
|||
No problem Charlie! Hope it works out for you. If you get one and reduce some 20 calibers to 19 let us know your progress. I'm sure a lot of us will be interested in the results.
Dan |
#20
|
|||
|
|||
After a quick look on Corbins site I came away thinking the reduction from .204 to .198 may be a step too far for that setup. Am I missing something here?
Ken.
__________________
" Pay it forward buddy" Get up each morning and don’t let the old man in. (Clint Eastwood). |
Thread Tools | |
Display Modes | |
|
|