#1
|
|||
|
|||
Question for Bullet makers with 30 cal Carbide Dies
This question is specifically for bullet makers making 30 cal 118 gr bullets concerning when their carbide dies were new.
- How much lube did you uses when Core Seating? & how long did you tumble them. - How much lube did you use before Point Up & how long did you tumble? - Did you see any diffrence on Paper if you used less lube or more. Thanks for your help, Ed |
#2
|
|||
|
|||
Quote:
Last edited by Randy Robinett; 02-14-2015 at 05:28 AM. |
#3
|
|||
|
|||
Randy, Thanks for your answers, this is exactly the info I was looking for. I am using Sta-Moly Jackets. I make a 1000 at a time, so will adjust accordingly.
Thanks again, Ed |
#4
|
|||
|
|||
Thanks Randy! That should inform most, varying weight of jacket right? I do not make 30 cals yet but I bet this would correlate to 22 cal as well. I appreciate your time.
__________________
I cannot believe there is a way I get to talk with some of the best die and bullet makers of our time. I really do get star struck here on the site. |
|
|