#1
|
|||
|
|||
My 17-223 build
Parts are showing up. Put the lower together and waiting for the rest.
[IMG][/IMG] This is small but don't want it to touch 1.5" hand guard Last edited by Wile E Steve; 05-18-2018 at 06:57 PM. |
#2
|
|||
|
|||
scope mounted
|
#3
|
|||
|
|||
cool. who's barrel did you go with? planning on shooting the 30's or standard 20-25's?
so hyperfire trigger eh. plan on spraying down the dog towns lol. |
#4
|
|||
|
|||
Detech is chambering a 24" 1-9 shilen turned down to a light contour. Have Reeeds 32 grain to try first. The Hyperfire 3 g is a pretty good 2.5# trigger with a short pull and just a touch of creep that i don't notice in the field calling coyotes. Got on sale for $115.00. Supposed to strike primers harder also. My second one. Scope is a 3x9 Trijicon accupoint which is a first for me. Wanted something lighter than my 20" bull barrel dpms. Have been known to spray a few at coyotes
|
#5
|
|||
|
|||
sounds like a fun build! I was thinking something like a 17 predator slinging 30's would be about as flat as it gets for the ar platform. i'm sure your 17-223 won't be far behind it
|
#6
|
|||
|
|||
I got cheap and went the easy route. Wanted a 17-204 or a 17-224 valkyrie but 17-223 dies are only 60$, didn't have to buy a reamer and the brass is cheap and good.
|
#7
|
|||
|
|||
Lapped upper receiver face
Kit called for 180 grit but the 600 worked fine. Last edited by Wile E Steve; 06-08-2018 at 01:48 AM. |
#8
|
|||
|
|||
Got the barrel checked out and snugged up.
|
#9
|
|||
|
|||
Installed adjustable gas block and gas tube.
|
#10
|
|||
|
|||
Time to work up some loads.
|
Thread Tools | |
Display Modes | |
|
|