#11
|
|||
|
|||
That’s the one and only reason I purchased a progressive (to form cases in multiple steps I was thinking 5 steps every pull on the ram).
I knew there was no way to load little tiny 17s on a progressive but boy was I wrong! My Hornady is an early model LNL with all the latest upgrades installed and several other nice to have options.
__________________
Shoot First... Ask questions later... On Saubier.com __________________ NRA Lifetime Endowment Member |
#12
|
|||
|
|||
Tried 20VT's from LC in a 550 Dillion
I tried forming 20VT's from LC brass on a 550 Dillon using three dies, a 221FB form die, a 20VT bump die, and a 20VT neck bushing die.
I abandoned the quest but I don't recall the exact problem(s) that surfaced. It may have been the long neck or HS. I still use the last two dies at 1 and 3 stations in the 550 after cutting off the necks, cleaning and chamfering. But I still expand the necks before turning on a single stage.
__________________
Rick M. Last edited by Ricco1949; 05-10-2019 at 02:59 PM. |
Thread Tools | |
Display Modes | |
|
|