|
#1
|
|||
|
|||
Has anyone bored the spindle threads and neck out of a FL die?
I have a few Redding Body Dies, that I use occasionally. I would have one in each of the calibers I shoot, if they were available. I think that a FL die could be altered, but the cost of a carbide drill in that size would make it cost prohibitive. I don't know what it would cost to have someone EDM it out, but I don't work for free and don't want anyone working on my stuff and not being fairly compensated for their time and investment in equipment.
Perhaps someone has done something similar and can give me a hint on how they accomplished the task and the degree of difficulty. I was also thinking that cutting the die off right at the neck to shoulder junction might accomplish the same objective. Redding body die: https://www.brownells.com/reloading/...prod79088.aspx Last edited by JDHasty; 09-19-2022 at 05:07 PM. |
#2
|
|||
|
|||
I've cut a couple rcbs fl dies and they were hardened. So you'll want a WC boring bar. Or else cut the die off at the neck with a grinder, or maybe open the neck with sandpaper/lapping compound, or soften the die, cut on it, and re-harden it.
|
#3
|
|||
|
|||
My gunsmith (retired tool and die guy) used a boring bar to create 6x45 and a 6x47 Remington body dies for me.
|
#4
|
|||
|
|||
Local EDM shop is going to do 4 for a hundred bucks. They wanted to wait until they talked to the “gun guy” to call back. I’d say that is a bargain.
Thank everyone for the responses. |
#5
|
|||
|
|||
Got mine for 10 bucks each
|
#6
|
|||
|
|||
I use carbide reamers.
Indicate it in with a gauge pin: Then in with the reamer: |
|
|