Saubier.com  



Go Back   Saubier.com > Saubier.com Forums > Small Caliber Discussion Board

Reply
 
Thread Tools Display Modes
  #11  
Old 08-28-2022, 05:56 PM
Jim D Jim D is offline
Supporting Member
 
Join Date: Oct 2009
Location: Iowa
Posts: 530
Default

Quote:
Originally Posted by moorepower View Post
Jim, did you turn to uniform, or do you have a tight neck chamber? Just asking because I bought a couple hundred of them.
I turned, because they were quite a bit thicker, than the cases, I have been forming. Hopping to get consistent neck tension.

I had a Forster neck turner already set up, for the LC formed brass.

So I turned about a hundred.

My rifles are factory Remingtons.

Jim
Reply With Quote
  #12  
Old 08-29-2022, 06:56 PM
moorepower moorepower is offline
Senior Member
 
Join Date: Mar 2011
Posts: 1,515
Default

Thanks! I was just wondering if I would have neck clearance issues without turning them. I probably need to get set up to neck turn .17's.
Reply With Quote
  #13  
Old 08-29-2022, 07:51 PM
Herb in Pa Herb in Pa is offline
Senior Member
 
Join Date: May 2010
Location: Latrobe, PA
Posts: 590
Default

I've had no problems with their 222 Remington Magnum brass...........use it for my 6x47 Remington.
Reply With Quote
  #14  
Old 09-30-2022, 10:01 PM
GrocMax GrocMax is offline
Senior Member
 
Join Date: Oct 2012
Location: McKinney TX
Posts: 488
Default

I used a SAAMI spec 17FB reamer and Lapua 221 doesn't need neck trimming.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:11 AM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.