#1
|
|||
|
|||
17 Hornet funnel
OK, I've read people can't find a good one or they're too expensive so I'm gonna help you guys out with the perfect 17 Hornet funnel for £1.99 GB
You just need to shave the end of the spout just a tiny bit to fit inside the length of the neck. It fit's as snug as a bug, it won't wobble, it's metallic so powder doesn't hardly stick, just a tap with the cup if it does. I love it to bits. I suppose I should say that I have no connection with this company but I love this so much I did consider reselling them. http://www.ebay.co.uk/itm/1-x-Gold-M...kAAOSwBLlU8GO6 |
#2
|
|||
|
|||
17 Hornet funnel
I guess I made it to simple. I took a fired 17 cal base into the local hardware store and in the household dept found a aluminum funnel, used to pour liquids into containers, that fit right tight and over the case neck.
works great and the powder drops into the case, with just a slight shake or tap on the funnel side. Ran me about 2.00, if I remember. Bill K |
#3
|
|||
|
|||
Nice one Bill. I guess most shooting folks will find a way to get it done. I will add that because mine fits inside to the start of the shoulder so no chance of powder sticking to the neck.
|
#4
|
|||
|
|||
Nice one i was going to buy one from spud reloading , thats saved me quite a bit of money.
|
#5
|
|||
|
|||
You can also use the disposable covers your doctor uses to look into your ears with.
__________________
Ron Reed Reed's Ammunition & Research, LLC www.reedsammo.com Main Page http://shop.reedsammo.com Online store info@reedsammo.com |
#6
|
|||
|
|||
Quote:
Just take off the plating to length of the neck of the case for a great fit with no sticking. |
#7
|
|||
|
|||
Cheers Toxo
|
#8
|
|||
|
|||
I wish I could find that same thing in the eBay USA listing. I even went to Walmart today in the houseware but couldnt find anything. I
Will have to keep looking. I need a 17 caliber funnel really bad now. |
#9
|
|||
|
|||
Spook1 do you want one sending over ?
|
#10
|
|||
|
|||
Mark527varmint
The shipping across the pond may not make it cost effective. Does anyone know what size diameter the opening of the drop tube is. I may have found some on Amazon with 1/8 opening in the tube. I was trying to figure how thick the neck on the funnel was to see if it would fit inside the case mouth of a 17 caliber |
Thread Tools | |
Display Modes | |
|
|