#11
|
|||
|
|||
L461 I’m leaning toward the 20ppc handy to know we’re there is a reamer but I may just buy my own reamer forgot to mention I have my own 20/222 reamer
I really wanted to get over 4000fps ,we’re or what did you use for dies for the 20ppc Thanks for all the reply’s ,I enjoy hearing about these 20s |
#12
|
|||
|
|||
I’ve also got a Tikka t3 .223 I may turn into a 20/222 as well one day
|
#13
|
|||
|
|||
I didn’t read through all the replies but if a 223 bolt face is what you end up going, I’d thinking it would be crazy not to build a 204 Ruger. I had one in a factory CZ and with factory 32 gr ammo, it shot a solid 1/2” group and sometime less. Then you don’t have to worry about the high cost of custom dies (but the same would be true for say a 20-221 or 20-222.
The 20 bobcat or duster are both an excellent option.... For me and without question, I would build Ray H. 20 Jav Imp. Dang, I might of just talked myself into a new project??? Might need to change up my 20 Habu Screw for a Jav Imp... I’ve recently been making 17 Jav Imp brass. This is about exactly the same as my 17 WS and I’m very fond of this case size.
__________________
Shoot First... Ask questions later... On Saubier.com __________________ NRA Lifetime Endowment Member |
#14
|
|||
|
|||
Dies are the easy bit Jack ,PPC body die,"S" type neck die and a 22 PPC seater.
The 22 PPC seater comes down to the Ogive 4,000 fps is not hard to get with the PPC case.
__________________
Speed Kills |
#15
|
|||
|
|||
I went with a true 20BRAI ... it’s very accurate, but I shoot benchrest at 600yds. It’s won me some wood & trinkets .. with 55 gr Bergers...
|
|
|