Picture of a 17HH next to 17AH

[larryinIA]

I just thought of a solution to your dilemma...you could send the rifle over to me...I will take care of the problem

What you do, is buy the dies when you see some that are for a hornet based case, it makes deciding what caliber to do easier. LOL.

Let me know if you need my FFL

Larry

Originally Posted by Remmynut

Dang......please dont like it guys.

I dont want to be more confused on the "next one".

Found another Prestige thinking it would be "cool" to have a somewhat kinda matched pair in dif calibers. Kinda thought a 20VT but this is a Hornet.

Trying real hard to NOT make it a

17 Mink OR...
K hornet OR....
17HH OR.....

? LOL

Leaving it ALONE is also another fine option. I'll say it again. YA'LL ARE A BAD INFLUENCE!!

I gotta get back to work and WORK SOME OVERTIME.....dang

[RebelSquirrel]

Originally Posted by GLWenzl

Ray H has a good fix for that nasty ole seating stem bite

Where is he? he needs to give it up!

[GLWenzl]

Originally Posted by RebelSquirrel

Where is he? he needs to give it up!

Ray beds the seating stem. The down side is you may need a different seating stem if you load more than one style bullet

[ray h]

Yes I used J-B and bed the bullet in the stem. I then take a small drill bit and drill a relief hole down in the very tip. This helps with varying length bullet tips. I recently use a hot glue gun on my 17 Squirrel seater stem. That work fine, took longer to heat the glue gun up than do the work. I mainly use Hornady VMaxs, maybe some of the VLDs would need new bedding. The hot glue is super fast to do.

[Lunde Sr]

The seating stem on the pictured AH was in a Wilson seater.
However, when seating Berger 20 grainers, I don't get that ring from the seater.
V