#1
|
|||
|
|||
WTB 350 magnum form trim die
Hello probably a long shot but looking for a form and trim die for the 350 Remington magnum from 7mm or 300 mag brass
if you might sell one if you have let me know thanks |
#2
|
|||
|
|||
I don't have a form die but I have made a fair amount of brass with just the standard sizer and seating dies. Take the seating stem out of the seating die and run full length belted brass through, trim and then size in sizing die. Cases will probably have to be neck turned or reamed but they will work to get you shooting.
|
#3
|
|||
|
|||
350 mag
Thank you I wondered if I could just run some 300 mag brass in my sizer to push it back and cut and form
thanks so much ill get some 300 mag brass and try this thanks |
|
|