![]() |
|
![]() |
|
#1
|
|||
|
|||
![]()
Hopefully someone has the answer. I would like to re-set the knobs on my SIII to zero. The instruction says what size allen key to use - either a 1.5 mm or the next size up in 64ths. I tried every metric and inch key and bit I have, one being the 1.5 mm, and nothing works. These are the knobs with the 3 grub screws around the circumference of the knob, not the ones with the torx through the center of the top. Anyone know what to do?
|
#2
|
|||
|
|||
![]()
Try a 1/16 th inch allen wrench. That's what mine takes. Good luck!
|
#3
|
|||
|
|||
![]()
Thanks. My 1/16 doesn't do the job. Maybe buy another and hope for a better fit. Does your 1/16" fit well?
|
#4
|
|||
|
|||
![]()
That's what fits my Sightron 6x24 scope. If a 1/16" doesn't work I do not know what to tell ya. Is it a allen type set? Dave
|
#5
|
|||
|
|||
![]()
They used to supply one in the box with the instructions and a yellow lens cleaning cloth. If you can’t find one, let me know and I will send you one. I have purchased enough Sightrons over the years I’m sure I have a spare floating around somewhere.
|
#6
|
|||
|
|||
![]()
Yep one in every box, that's why I have a jar full of Allen keys...
![]() |
#7
|
|||
|
|||
![]() Quote:
Now, I discovered that one of the 3 holes in the windage knob is missing its grub screw. Of course, it was the one easiest to get to, and I was trying to make an allen wrench fit the screw that wasn't there. Don't suppose anyone has a spare grub screw. Thanks for helping me. Harold |
![]() |
Thread Tools | |
Display Modes | |
|
|