#1
|
|||
|
|||
RCE Co
Hi there,
newly registered but not new to the forum or accurate rifles. I am about to take the leap into swaging my own bullets, but have been unable to get my computer to bring up Richard Corbins e-mail address froim the RCE Co site for some reason. Could anyone advise what the correct e-mail address is to contact RCE Co, LLC? Thanks in advance. |
#2
|
|||
|
|||
__________________
There are three kinds of men: The one that learns by reading... The few who learn by observation... And the rest, who have to piss on the electric fence for themselves...!! |
#3
|
|||
|
|||
Thankyou
I have viewed the website, but cannot open the send e-mail window (damn computers!) Much apreciated! |
#4
|
|||
|
|||
Richard.
Dave, his brother, has swage.com and corbins.com etc. Richard has had rceco.com (Richard Corbin Engineering company [co]) and just lately, bulletswagers.com or bulletswager.com... I forget, its new...
The Neimi's are very hard to find but in the "loup." Mr. Blackmon, Lousiana, is another source. Butch Harrifield does jackets. As do Sierra, J-4 (brunoshooters.com best source I know of), and Dave Corbin... then there is the equipment to make your own... great life if you can stand the repitition. luck. |
#5
|
|||
|
|||
Thanks for the information, I have been in touch with Richard and a Walnut Hill press and die sets for various calibres should be sent to me early next year.
Awaiting reply from Bruno re export permits and jackets.... |
Thread Tools | |
Display Modes | |
|
|